About Media - Honeywell PC42t User Manual

Status LED States (continued)
LED State
Green (blink)
Green (fast blink)
Orange (solid)
Orange (blink)
Red (blink)
Red and green
(alternating blink)

About Media

The printer can print on labels, tags, and continuous (receipt and linered)
media. The printer supports both direct thermal and thermal transfer
media. To use thermal transfer media, you also need thermal transfer
ribbon. The PC42t printer supports media from 1 to 4.33 inches (25 to
110 mm) wide.
PC42t Desktop Printer User Guide
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
Description
The printer is just starting up.
Printing is paused. Press the Print button to
resume printing or press and hold the Print
button for three seconds to cancel the print job.
The printer is communicating.
The simulator (ZSim and ESim) is starting up.
The printhead is too hot. Wait for the printhead
to cool down to an acceptable temperature
before it can resume printing.
The printer is upgrading its firmware from an
inserted USB flash drive. Remove the USB
flash drive after the LED turns solid green.
The printer is in Error mode. The printer may be
out of ribbon, have ribbon installed (when
configured for direct thermal), be out of media,
have the printhead lifted, have a label
obstructing the printing path, or you may not
have performed a testfeed (hold Print button
until several labels print).
After you have fixed the error, press the Print
button to restart printing.
The printer is experiencing a hardware issue.
Return the printer to Honeywell for service. For
help, see "Product Service and Repair" on
page vii.
V10 CONSUMIBLES S.L.
Chapter 1 — About the Printer
5