Makita M1902 Technical Information page 18

Wiring to Main frame complete
If Terminal block is used, do not put the
lead wires under Terminal block.
Main frame complete
Switch
Put Field lead wires
(orange, purple)
between the rib on
Terminal plate and the
inner wall.
Rib on Terminal plate
Put the lead wire (purple) into Lead wire holder B.
A
Edge
A
Pass-through slot
Fig. 7-2
Put Noise suppressor in this space so that the lead wires are routed as shown below.
(If Noise suppressor is used.)
Rib
Field
Terminal block (if used)
Inner
wall
Cross section of A-A
18 / 19
Noise suppressor (if used)
Do not put the lead wires on the ribs and Boss.
Rib
Inner wall
Lead wire
holder B
Route Field lead wires through the
pass-through slot on Motor housing so as
not to damage them with edge.
Edge
Boss
Lead wire holder A
Put Field lead wires into
Lead wire holder A so
that they are not
loosened between Lead
wire holder A and Field.