Preparation; Installation; Configuration; Connecting To Network - Honeywell OneWireless XYR 6000 User Manual

3.1

Installation

Refer to the XYR 6000 Transmitter Quick Start Guide (document 34-XY-25-21) for installation, mounting
and wiring of your XYR 6000 transmitter.
3.2

Configuration

The XYR 6000 Transmitter contains the electronics interface compatible for connecting to the
OneWireless network. An operator uses the OneWireless User Interface to configure blocks, to change
operating parameters, and to create linkages between blocks that make up the transmitter's configuration.
These changes are written to the transmitter when it is authenticated by a security key.
3.3

Connecting to network

Use Provisioning Device to connect your transmitter to the OneWireless network. See page 28.
3.4

Calibrating the transmitter

Overview

For all calibration methods, OneWireless User Interface must be used to unlock and take the channel out of
service. You can set the zero offset at the transmitter by use of the infrared port. Additional calibration
commands such as upper and lower trim are available in OneWireless User Inteface.

Calibrate zero

Calibrates the sensor to correct the input measurement due to fill fluid and transmitter position effects once
the transmitter is installed and operating under process conditions.
ATTENTION
Setting user trim points will effectively override the calibration zero. Normally
the calibration zero is only required if you do not intend to provide process-
specific trim points.
Revision 3 OneWireless XYR 6000 ISA100.11a Compliant Pressure Transmitter User's Manual
March 2012

3. Preparation

3. Preparation
3.1. Installation
11