Honeywell OneWireless XYR 6000 User Manual page 33

Transmitter OneWireless User
display Inteface display
OVR LOAD Over Load
CAL ERR Calibration Error
LOW BAT Low Battery
LOW PWR Low Power
NO RADIO Radio Interprocessor
Comm Error
The following status messages have multiple meanings. Refer to OneWireless UI Device Status for exact cause.
INP FAIL Input Failure
INP FAIL A/D Failure
E FAIL A/D Failure
E FAIL Electronics Failure
E FAIL* NVM Fault*
E FAIL* Program Memory Fault*
E FAIL* RAM Fault*
The following statuses are displayed only in OneWireless UI Device Status.
Revision 3 OneWireless XYR 6000 ISA100.11a Compliant Pressure Transmitter User's Manual
March 2012
Definition
The applied pressure has
exceeded the limit
defined by the meter
body characterization
data.
Calibration Data Invalid
or could not be read.
Battery Voltage Critically
Low
External Power Critically
Low
Radio Board is not
accessible.
Input Error
Diagnostics detected
defect with Analog to
Digital Converter.
Diagnostics detected
defect with Analog to
Digital Converter.
Electronic Failure
detected on Sensor
Board. Could be caused
by one of the status
items marked by *.
Startup diagnostics
detected defect in
Sensor Non-Volatile
Memory
Startup diagnostics
detected defect in
Sensor Read Only
Memory
Startup diagnostics
detected defect in
Processor Random
Access Memory
5. Operation
5.3. Transmitter PV display
What to do
Determine cause of over pressure.
Use Cal Clear, Restore, or User
Calibrate.
Replace batteries as soon as
possible. See page 40.
Check external 24V power supply
Restart both the radio and sensor.
If condition persists, replace
sensor module. See page 38.
Possible meter body sensor
failure.
Replace sensor module. See page
38.
Replace sensor module. See page
38.
Restart both the radio and sensor.
If condition persists, replace
sensor module. See page 38.
Replace sensor module. See page
38.
Replace sensor module. See page
38.
Replace sensor module. See page
38.
23