Makita TD001G Instruction Manual page 9

By registering a certain application mode to the tool, you can
switch to the registered application mode by just pressing the
quick mode-switching button (quick mode-switching function).
NOTE: When none of the lamp on the panel is lit,
pull the switch trigger once before pressing the quick
mode-switching button.
NOTE: You will not be able to change the application
mode if you do not operate the tool for approximately
one minute. In this case, pull the switch trigger
once and press the button,
mode-switching button.
NOTE: Refer to "Registering the application mode"
in "Quick mode-switching function" section for how to
register the application mode.
Quick mode-switching button
The function of the quick mode-switching button varies
depending on whether you have registered the applica-
tion mode to the tool.
1
► 1. Quick mode-switching button
Quick reference
The following table shows the functions of the quick mode-switching button.
indicates the quick mode-switching button.
Button(s) / Purpose
(When quick mode-switching function
is OFF)
Changing the impact force by the quick
mode-switching button
(When quick mode-switching function
is ON)
Switching to the registered application
mode
+
Registering the application mode
button, or quick
Action
Press
Press
Press and hold (each button)
9 ENGLISH
When the application mode is not registered:
The level of impact force changes every time you press
the quick mode-switching button. The front lamps on
both sides will flash once when the impact force is
changed by pressing the quick mode-switching button.
When the application mode is registered:
The tool switches between the registered application mode
and current application mode every time you press the
quick mode-switching button. The front lamps on both sides
will flash once when the application mode is changed by
pressing the quick mode-switching button.
NOTE: When the lamp status is off, the front lamps
will not flash even when the application mode is
changed by pressing the quick mode-switching button.
NOTE: Refer to "Registering the application mode"
in "Quick mode-switching function" section for how to
register the application mode.
Disabling the quick mode-switching button
You can also disable the quick mode-switching button. After
disabling, the quick mode-switching button will not work for
changing the impact force and switching the application mode.
To disable the quick mode-switching button, press and
hold the quick mode-switching button and the button
the same time until the all lamps on the panel blink.
To resume the quick mode-switching button, perform
the same procedure as above again.
NOTE: Registering and erasing the application mode can
be performed even if the quick mode-switching button is
disabled. After registering or erasing the application mode,
the quick mode-switching button will be activated.
The front lamps on the tool flash once.
The front lamps on the tool flash once.
Example: Wood mode is registered
The lamp of desired application mode
blinks.
How to confirm
at