Neighbor Interface-Id Unnumbered - Cisco NCS 1004 Command Reference Manual
Hide thumbs
Also See for NCS 1004:
- Hardware installation manual (70 pages) ,
- Manual (52 pages) ,
- Quick start manual (6 pages)
Table of Contents
Advertisement
Commands
neighbor interface-id unnumbered
To specify the neighbor's optical interface ID of an LMP link for a GMPLS UNI controller, use the neighbor
interface-id unnumbered command in GMPLS-UNI controller configuration mode.
neighbor interface-id unnumbered interface-id
Syntax Description
interface-id
None
Command Default
LMP GMPLS-UNI controller configuration
Command Modes
Command History
Release
Release
7.0.1
Example
The following example shows how to specify the optical interface ID of an LMP neighbor.
RP/0/RP0/CPU0:ios(config)#lmp
RP/0/RP0/CPU0:ios(config-lmp)#gmpls optical-uni
RP/0/RP0/CPU0:ios(config-lmp-gmpls-uni)#controller Optics0/0/0/0
RP/0/RP0/CPU0:ios(config-lmp-gmpls-uni-ctrl)#neighbor interface-id unnumbered 2130706976
RP/0/RP0/CPU0:ios(config-lmp-gmpls-uni-ctrl)#
Specifies the optical interface ID of the neighbor.
Modification
This command is
introduced.
neighbor interface-id unnumbered
Command Reference for Cisco NCS 1004
51
- Quick Links:
- Controller Optics
Hide quick links:
Advertisement
Table of Contents
