External Power Port - Honeywell PX940 Installation Instruction

Pin Signal
9 Reserved
10 Ribbon/
Media low
11 Verification
failed
12 +24VDC
13 +5VDC
14 Power
ground

External Power Port

External Power Port Pinouts
Pin Signal
1 +5VDC
2 Signal
ground
3 +24VDC
4 Power
ground
5 +24VDC
10
Type Description
Output Goes LOW when the ribbon/media roll
diameter drops below a predefined level,
otherwise Goes HIGH.
Media low is supported only by I-Style.
Goes LOW when the printer encounters
Output
Verification failed error.
Goes HIGH when the error is cleared.
Output Power for external devices: +24VDC (±10%)
@2A.
Power Voltage supply for external sensors.
Configurable for internal or external source.
Ground +24VDC return.
Type Description
Input +5VDc input for distribution through Applicator
Port connector (Z-Style pin 2, S-Style pin 13)
Input Signal return for +5VDC supply (Z-Style pin 1,
S-Style pin 2)
+24VDC input for distribution through Applicator
Input
Port connector (Z-Style pin 7, S-Style pin 12)
Power return for input (Z-Style pin 8, S-Style pin 2)
Input
+24VDC input for distribution through Applicator
Input
Port connector (Z-Style pin 7, S-Style pin 12)
PX940 Applicator Interface Installation Instructions