Error Messages - Honeywell PX940 Installation Instruction

Error Messages

Message:
Cause:
Error Number:
Message:
Cause:
Error Number:
Message:
Cause:
Error Number:
Message:
Cause:
Result:
Error Number:
Message:
Cause:
24
ERRNOAPP
Operation not allowed. Applicator Port disabled.
Application sent an applicator port command to the printer
and the applicator port is disabled.
88
ERRAPP
Operation not allowed. Applicator Port enabled.
Application sent the Fingerprint command PORTOUT(PORT)
ON|OFF on a port used by the applicator port when the
applicator port is enabled.
89
ERRINPUTON
Operation not allowed in Direct Protocol.
Running the PORTOUT.DATAREADY ON|OFF or
PORTIN.<SIGNAL> GOSUB XXX commands when the printer
is using Direct Protocol.
90
EAPPERR1
Applicator Error 1.
AppErr1 in signal detected.
Activates event in System Health Monitor (SHM).
1340
EAPPERR2
Applicator Error 2.
AppErr2 in signal detected.
PX940 Applicator Interface Installation Instructions