Display Messages - Honeywell PX940 Installation Instruction

Display Messages

These messages appear in the printer display under certain conditions when a
PRINTFEED command is run.
Message:
Cause:
Message:
Cause:
26
APPLICATOR PORT: Wait for signal.
Running a PRINTFEED command blocks execution until a
startprint signal is received. The message appears when
execution has been blocked for a few seconds.
APPLICATOR PORT: Wait for reprint.
Running a PRINTFEED -1,1 command blocks execution until a
reprint signal is received. The message appears when execution
has been blocked for a few seconds.
PX940 Applicator Interface Installation Instructions