Section 3: Wiring - Honeywell Gamewell FCI ILI-MB-E3 Product Installation Document

Section 3: Wiring

3.1 Signaling Line Circuits
The ILI-MB-E3 provides two, 24 VDC Class A, Style 6, 7 or Class B, Style 4
signaling line circuits. See Figure 3.1.1 for wiring information. Style 7 wiring
requires the use of an M500X Isolator Module (ILI-MB-E3) on both sides of a
device.
ILI-MB-E3 Wiring Designations:
SLC 1 Style 4
SLC 2 Style 4
SLC 1 Style 6
SLC-2 Style 6
(Polarity markings indicate the polarity that should be maintained throughout the
circuit. Polarity connected to the circuit must be observed on all devices).
Circuit Ratings:
24 VDC (nominal)
Current:
Ground fault test
impedance:
Wiring:
Class 2 Power-Limited,
E3 Series Releasing Feature
To actuate the E3 Series Releasing feature, use the signaling line circuit, Honeywell model, TC810S1000, Releasing Control
Module. For additional information on the Honeywell TC810S1000 device, refer to the Honeywell, TC810S1000 Releasing
Control Module Installation and Maintenance Instructions, P/N:I56-3367-000.
NOTE 1: SURVIVABILITY CLAUSE:
Per the National Fire Alarm Code, NFPA 72, all circuits necessary for the operation of the notification appliances shall be
protected until they enter the evacuation signaling zone that they serve. Any of the following methods shall be considered
acceptable as meeting these requirements.
1) A 2-hour rated cable or cable system
2) A 2-hour rated enclosure
3) Performance alternatives approved by Authority Having Jurisdiction (AHJ)
8
TB4-8 (+), TB4-7 (-)
TB4-4 (+), TB4-3 (-)
TB4-8 OUT, TB4-6 RETURN
TB4-7 OUT, TB4-5 RETURN
TB4-4 OUT, TB4-4-2 RETURN
TB4-2 OUT, TB4-1 RETURN
0.051 amp Max (supervisory)
0.136 amp max. (alarm)
0.100 amp max. Steady State
(short circuit)
40 Ohms max. line impedance
0.5 µf max. line capacitance
Zero Ohms
18 AWG minimum, twisted-pair, unshielded
Supervised
ILI-MB-E3 Product Installation Document — P/N 9000-0579:M7 07/02/2018
INPUT/CONTROL
MODULE
SMOKE/HEAT
CO/SENSOR
B200S
SOUNDER BASE
(ILI-MB-E3 only)
NCM-1
B (-)
ILI-MB-E3
A (-)
DOTTED LINES INDICATE CLASS A,
STYLE 6 WIRING.
Figure 3.1.1 Signaling Line Circuits
B (+)
A (+)