Section 4: E3 Series Configurations; Section 5: Programming Requirements - Honeywell Gamewell FCI ILI-MB-E3 Product Installation Document

Section 4: E3 Series Configurations

Minimum E3 Series Configuration
The minimum E3 Series configuration to use in a working system requires the following:
A) ILI-MB-E3, Intelligent Loop Interface, Main Board
NOTE: In a standard E3 Series configuration, install only one ILI-MB-E3 for one PM-9/PM-9G power supply connected to an
FACP cabinet.
B) PM-9/PM-9G Power Supply
C) LCD-E3, LCD-SLP or NGA Display Module (only one module is required per a Networked System)
Optional E3 Series Configuration
The following optional modules can be used with the ILI-MB-E3 in an E3 Series configuration.
A) RPT-E3-UTP, Repeater Module (Required for Distributed Network Systems)
(The RPT-E3-UTP is required when you use the NGA).
B) DACT-E3, Digital Alarm Communicator Transmitter
C) INI-VG Series, (Intelligent Network Interface - Voice Gateway Modules (First/Second/Third Generation)
D) ANX, Addressable Node Expander
(Use the ANX for Fire applications only).
E) ILI-S-E3, Intelligent Loop Interface-Expander Board
(Use up to eight ILI-S-E3 modules in an E3 Series configuration).
F) ILI95-S-E3, Intelligent Loop Interface95-Expander Board
Display Panels:
G) ANU-48, Remote LED Driver Assembly
H) ASM-16, Addressable Switch Module
I) LCD-E3, LCD Display Module
J) LCD-SLP, Liquid Crystal Display-Small Loop Panel
K) LCD-7100/RAN-7100
L) NGA, Network Graphic Annunciator

Section 5: Programming Requirements

This product uses the CAMWorks™ Software Program. Installers must be Gamewell-FCI Factory Certified to program this
product. For additional information on this product, contact the Gamewell-FCI Customer Support to schedule the Factory Certified
Training.
NOTE: For information on the latest version of CAMWorks, see the Gamewell-FCI website, www.gamewell-fci-esd.com.
ILI-MB-E3 Product Installation Document — P/N 9000-0579:M7 07/02/2018 17