Honeywell Gamewell FCI ILI-MB-E3 Product Installation Document page 5

2.5 ILI-MB-E3 Installation Instructions
1. Remove the ILI-MB-E3 sub-assembly from its static-shield bag, observing proper static protection measures.
2. Visually inspect the unit for damage.
If any components are damaged, notify the shipping carrier immediately. Report missing components to Gamewell-FCI
Customer Service.
3. Use the Hardware Kit provided with the unit.
4. The ILI-MB-E3 sub-assembly can be installed in several types of configurations in the E3 Series cabinets and Retrofit cabinets.
To determine the ILI-MB-E3 installation that you require,
- E3 Series Cabinets B, C, D, Retrofit, DR-C4/DR-D4 and EQ Cabinets Installation Instructions, P/N: LS10082-000GF-E
- E3 Series, Remote Annunciator Display and Retrofit Cabinets Installation Instructions, P/N: LS10083-000GF-E
2.5.1 ILI-MB-E3 Installed to the Cabinet B Backbox
1. Align and mount the ILI-MB-E3 to the studs in the backbox.
2. Insert eight standoffs (3/16" hex, #4-40 x 1.25") in the eight-hole mounting pattern and secure the standoffs to the backbox as
shown in Location 1 of the figure below. (Note: PCB orientation).
NOTE: You can use standoffs to mount the DACT-E3/RPT-E3-UTP or the ANX on top of the ILI-MB-E3.
ILI-MB-E3
(NOTE: PCB
ORIENTATION)
STANDOFF,
3/16", (#4-40 x 1.25")
ILI-MB-E3 Product Installation Document — P/N 9000-0579:M7 07/02/2018
8-HOLE MOUNTING
8 PLACES
1
Figure 2.5.1.1 ILI-MB-E3 Installed to the Cabinet B Backbox
refer to the following documents:
CABINET B,
BACKBOX
ILI-MB-E3,
PATTERN
1
N
OTE: THE ANX CAN
MOUNT ON TOP OF THE
ILI-MB-E3.
(IN PLACE OF THE
DACT-E3/RPT-E3-UTP).
1
1
5