Advertisement
R
epair
<8> Assembling yoke unit
* Assemble yoke unit to motor housing with adjusting its cut part to the rib on the bottom
of motor housing.
* Be careful, not to pinch your finger when assembling armature to motor housing,
because armature is pull strong into motor housing by the magnet power of yoke unit.
Armature
<9> Adjusting the saw blade's angle
* Adjust the saw blade to right angle to turn base and guide fence with the repairing tool
No.1R208 as illustrated in Fig.13.
No.1R208 : 90 Degrees set square
25mm
* Adjust the saw blade to 45
in Fig.14.
No.1R207 : 45 Degrees set square
25mm
Yoke unit
Fig.12
70mm
20mm
75mm
o turn base with the repairing tool No.1R207 as illustrated
°t
60mm
20mm
75mm
Fig.14
Motor housing
Fig.13
P 7 / 9
Adjust this cut to
the rib on the bottom of
motor housing.
Advertisement
