Advertisement
R
epair
<2> Removing and assembling blade case section
[1] Removing
Lock handle in the raised position by pushing in
stopper pin as illustrated in Fig.1.
[2] Loosen the hex bolt holding center cover with
socket wrench (standard equipment) by turning it
counterclockwise as illustrated in Fig.2.
[3] Raise center cover and safety cover. Press shaft lock
to lock spindle. And then, remove hex flange head bolt
holding the saw blade with socket wrench by turning it
clockwise as illustrated in Fig.3.
[4] Remove safety cover section by loosening flat head screw M5
as illustrated in Fig.3, and dust nozzle from the machine.
[5] Loosen hex socket head bolt M6x20 holding link plate
and hex socket head bolt M6x10 holding rod 16-100
as illustrated in Fig.4.
[6] Pull stopper pin while holding motor unit (motor housing, blade case
and handle set), and raise motor unit till it comes to out of effect
of torsion spring. And then, remove motor unit after taking off
rod 16-100.
Motor unit
Link plate
Right side view
Stopper pin
Shaft lock
Flat head screw M5
Hex socket
Motor unit
head bolt M6x20
Stopper pin
Lever
Arm
Fig.4
Motor unit
Rod 16-100
Fig.5
Fig.1
Fig.2
Safety cover
Center cover
Fig.3
Hex socket
head bolt M6x10
Torsion spring
Front side view of
arm section
Stopper pin
Lever
Arm
P 3 / 9
Advertisement
