Cisco 8832 Manual page 9

Your Phone
Install the Wireless Expansion Microphones
The conference phone provides the option of connecting two wireless expansion microphones.
Note You must use either two wired microphones or two wireless microphones with the phone, but not a mixed
combination.
When the phone is in a call, the LED on the expansion microphone is lit green. To mute the expansion
microphone, press the Mute key. When the microphone is muted, the LED is lit red. When the battery in the
microphone is low, the battery indication LED blinks rapidly.
Before you begin
Disconnect the wired expansion microphones before you install wireless expansion microphones. You cannot
use both wired and wireless expansion microphones at the same time.
Procedure
Step 1 Position the table mount plate on the table surface location where you want to place the microphone.
Step 2
Remove the adhesive for the double-stick tape on the bottom of the table mount plate. Place the table mount
plate to adhere to the table surface.
Step 3
Attach the microphone to the table mount plate. Magnets are embedded in the microphone to snap the unit
into place.
You can move the microphone and attached table mount to a different location on the table surface as needed.
Use care when moving to protect the unit.
Related Topics
Pair a Wireless Microphone
Before you begin
Unplug any wired microphones.
Procedure
Step 1
Press Settings.
Step 2 Select Admin Settings > Microphones > Wireless microphones.
Step 3
Select either Microphone 1 or Microphone 2 and press Pair.
If a microphone is already linked to a particular channel, the phone screen shows that the microphone is paired.
Wireless Expansion Microphone, on page 20
Install the Wireless Expansion Microphones, on page 9
Install the Wireless Expansion Microphones
Your Phone
9