Other Risks; Electrical Safety - Black & Decker BDHR202 Original Instructions Manual

• Before drilling into walls, floors or
ceilings, check for the location of wiring
and pipes.
• Avoid touching the tip of the drill bit
after drilling so as to avoid scalding.
• The intended use is described in this
instruction manual. The use of any
accessory or attachment or performance
of any operation with this tool other than
those recommended in this instruction
manual may present a risk of personal
injury and/or damage to property.
Safety of others
• This appliance is not intended for use by
persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning use
of the appliance by a person responsible
for their safety.
• Children should be supervised to ensure
that they do not play with the appliance.

Other risks

Additional residual risks may arise when
using the tool which may not be included in
the enclosed safety warnings. These risks
can arise from misuse, prolonged use etc. In
spite of the application of the relevant
safety regulations and the implementation
of safety devices, certain risks cannot be
avoided.
These are:
• Injuries caused by touching any
rotating/moving parts.
• Injuries caused when changing any parts,
blades or accessories.
• Injuries caused by prolonged use of a
tool. When using any tool for prolonged
periods ensure you take regular breaks.
• Impairment of hearing.
• Health hazards caused by breathing dust
developed when using your tool
(example:- working with wood, especially
oak, beech and MDF.)
(Original instructions)
Labels on tool
The following symbols are shown on the
tool:
Warning! To reduce the risk of injury,
the user must read the instruction
manual.
Position of Date Barcode (Fig. C)
The Date Code (12), which also includes the
year of manufacture, is printed into the
housing.
Example:
Year of manufacturing

Electrical Safety

Your tool is double insulated;
therefore no earth wire is required.
Be sure to check that the power
supply corresponds to the voltage on
the rating plate. Corresponds.
• If the supply cord is damaged, it must be
replaced by the manufacturer or an
authorised Black and Decker Service
Centre in order to avoid a hazard.
Using an Extension Cable
If it is necessary to use an extension cable,
please used an approved extension cable
that fits the tool's power input specifications
(please refer to the technical data). The
minimum cross- sectional area of the
conducting wire is 1.5 sq. mm. Cables should
be untangled before reeling up.
Please refer to the following table.
Cable cross-sectional area (mm 2 ) Cable rated current (Ampere)
0.75
1.00
1.50
2.50
4.00
ENGLISH
2015 XX JN
6
10
15
20
25
Cable length (m)
7.5 15 25 30 45 60
5