Add A Data Format - Honeywell N3680 User Manual

If you have changed data format settings, and wish to clear all formats and return
to the factory defaults, scan the Default Data Format code below.

Add a Data Format

Step 1.
Step 2.
Step 3.
Note: 099 indicates all terminal types.
Step 4.
If you are creating a data format for Batch Mode Quantity, use 35 for the Code I.D.
Note: 99 indicates all symbologies.
Step 5.
Note: 9999 indicates all lengths.
Step 6.
Step 7.
62
Scan the Enter Data Format symbol
Select Primary/Alternate Format
Determine if this will be your primary data format, or one of 3 alternate
formats. This allows you to save a total of 4 different data formats. To
program your primary format, scan 0 using the
inside the back cover of this manual. If you are programming an alternate
format, scan 1, 2, or 3, depending on which alternate format you are
programming. (See "Primary/Alternate Data Formats" on page 74 for
further information.)
Terminal Type
Refer to Terminal ID Table
for your PC. Scan three numeric bar codes on the inside back cover to
program the scan engine for your terminal ID (you must enter 3 digits).
For example, scan 0 0 3 for an AT wedge.
Code I.D.
In the Symbology Charts,
which you want to apply the data format. Locate the Hex value for that
symbology and scan the 2 digit hex value from the
inside the back cover of this manual.
Length
Specify what length (up to 9999 characters) of data will be acceptable for
this symbology. Scan the four digit data length from the
Chart inside the back cover of this manual. For example, 50 characters is
entered as 0050.
Editor Commands
Refer to Data Format Editor Commands
represent the command you want to enter.
Scan Save to save your data format, or Discard to exit without saving your
changes.
Enter Data Format
* Default Data Format
(page
(page 64) and locate the Terminal ID number
beginning on page 171, find the symbology to
(page 64). Scan the symbols that
N3680 Decoded Engine User Guide
62).
Programming Chart
Programming Chart
Programming