Show Data Format; Add A Data Format - Honeywell Voyager XP 147 Series User Manual

Show Data Format

Scan the barcode below to show current data format settings.

Add a Data Format

Step 1.
Step 2.
Step 3.
Note: 099 indicates all terminal types.
Step 4.
Note: If you are creating a data format for Batch Mode Quantity, use 35 for the Code I.D.
Step 5.
Note: 9999 indicates all lengths.
Step 6.
Step 7.
100
Scan the Enter Data
Select Primary/Alternate Format
Determine if this will be your primary data format, or one of 3 alternate
formats. This allows you to save a total of 4 different data formats. To
program your primary format, scan 0 using the
you are programming an alternate format, scan 1, 2, or 3, depending on
which alternate format you are programming. (See
Data Formats
Terminal Type
Refer to Terminal ID Table
Scan three numeric barcodes on the
scanner for your terminal ID (you must enter 3 digits). For example, scan
0 0 3 for an AT wedge.
Code I.D.
In the Symbology
the data format. Locate the Hex value for that symbology and scan the 2
digit hex value from the
Length
Specify what length (up to 9999 characters) of data will be acceptable for
this symbology. Scan the four digit data length from the
Chart. (Note: 50 characters is entered as 0050. 9999 is a universal
number, indicating all lengths.)
Editor Commands
Refer to Data Format Editor
the command you want to enter.
Scan Save to save your data format, or Discard to exit without saving your
changes.
Enter Data Format
DFMBK3?.
Data Format Settings
Formatsymbol.
for further information.)
and locate the Terminal ID number for your PC.
Charts, find the symbology to which you want to apply
Programming
Commands. Scan the symbols that represent
Programming
Primary/Alternate
Programming Chart
Chart.
Voyager XP User Guide
Chart. If
to program the
Programming