Check Digit
No Check Digit indicates that the scanner reads and transmits bar code data with
or without a check digit.
When Check Digit is set to Validate, but Don't Transmit, the unit only reads NEC 2
of 5 bar codes printed with a check digit, but will not transmit the check digit with
the scanned data.
When Check Digit is set to Validate and Transmit, the scanner only reads NEC 2 of
5 bar codes printed with a check digit, and will transmit this digit at the end of the
scanned data. Default = No Check Digit.
NEC 2 of 5 Message Length
Scan the bar codes below to change the message length. Refer to
Description
= 2-80. Minimum Default = 4, Maximum Default = 80.
Minimum Message Length
Code 93
< Default All Code 93 Settings >
84
* No Check Digit
Validate and Transmit
(page 76) for additional information. Minimum and Maximum lengths
Validate, but Don't Transmit
Maximum Message Length
N3680 Decoded Engine User Guide
Message Length