Removing The Front Cover; Installing The Front Cover - Cisco 6400 Maintaining

Replacing the Front Cover

Removing the Front Cover

To remove the front cover, first remove the bezel plugs:
Insert the tip of a flat-blade screwdriver into the indentation between the top and bottom of the plug.
Step 1
Step 2 Rotate the screwdriver blade 90 degrees, pushing out the top of the plug
Step 3 Remove the plug with your fingers.
Step 4 Then firmly grasp the cover with both hands, lift upward as far as possible (about one inch), and pull
forward.
Figure 5-3
The cover is secured by four posts. Avoid bending or twisting cables and connectors.
Note

Installing the Front Cover

To install the front cover:
Line up the hole in each corner of the cover with the four posts on the chassis
Step 1
Step 2 Gently but firmly push the cover onto the posts and slide downward to secure.
Step 3 Insert one of the bezel plugs into a corner hole, below the post.
Cisco 6400 Hardware Installation and Maintenance Guide
5-6
Removing Bezel Plugs
FANS OK
FAN FAILURE
Cisco 6400
MULTI-FAN FAILURE
POWER
FAULT
MISWIRE
POWER POWER
FAULT
FAULT
MISWIRE MISWIRE
FANS OK
FAN FAILURE
Cisco 6400
MULTI-FAN FAILURE
POWER
FAULT
MISWIRE
POWER POWER
FAULT
FAULT
MISWIRE MISWIRE
Chapter 5 Maintaining the Cisco 6400
(Figure 5-3).
(Figure 5-4).
OL-2133-02