Risk Of Electrical Shock - Honeywell Limitless WDRR Series Quick Start Manual

Limitless™ WDRR Series
1.1 Antenna Connection (refer to Figure 1)
WARNING
RF EXPOSURE
* To satisfy FCC RF exposure requirements for mobile transmitting devices, a separation distance of 20 cm
[7.87 in] or more should be maintained between the antenna of this device and persons during device
operation. To ensure compliance, operation at closer than this distance is not recommended. The antenna
used for this transmission must not be co-located in conjunction with any other antenna or transmitter.
Failure to comply with these instructions could result in death or serious injury.
A direct mount antenna (either straight or tilt & swivel) can be easily mounted by threading the mating RP-SMA
plug of the antenna to the RP-SMA jack
A remote mount antenna requires the use of an extension cable to allow the antenna to be mounted in a different
location than the WDRR location. The extension cable will need to have one end with a RP-SMA plug connector
which will mate with the WDRR RP-SMA jack
ATTENTION
Only Honeywell antennas types should be used. The antenna gain when using the WDRR should
meet the Country Communication Agency requirements for the specific country the WDRR is being
used in. Contact Honeywell for further information.
1.2 E lectrical Connections (refer to Figure 1)
2 5 B
WARNING

RISK OF ELECTRICAL SHOCK

* Potential shock hazard where HAZARDOUS LIVE voltages greater than 30 Vrms, 42.4 Vpeak, or 60 Vdc
may be accessible.
Failure to comply with these instructions could result in death or serious injury.
ATTENTION
Do not run the electrical wires in parallel and close proximity to the antenna or antenna cable.
Power supply connections: The Limitless™ WDRR Series has two cage clamp screw terminals on the bottom
right of the housing. A regulated voltage supply of 10 Vdc to 28 Vdc needs to be connected to the terminals

identified as "+"
and "-"
number, WDRRPWRASM, will need to be used and electrical connections made as shown in Figure 2.
NOTICE
The measured voltage across the output "-" terminal  and the output "+" terminal  is
nominally 1.5 Vdc less than the voltage supplied.
NOTICE
ANATEL requires the use of Honeywell part number WDRRPWRASM.

on the WDRR. Tighten the connection until finger tight.

under the same mounting procedure as the direct mount antenna.

power supply terminals. Notice: if the product is being used in Brazil, Honeywell part
50063986
Issue 2,
Honeywell Sensing and Control 3