Configuration Dip Switches; Power Led - Honeywell Limitless WDRR Series Quick Start Manual

Limitless™ WDRR Series

1.3 Configuration DIP switches

The NPN/PNP-type outputs

may be connected for use as: NPN-type current sinking or totem pole; PNP-type current sourcing or totem pole.
The configuration DIP switches
PLC as follows:
OUTPUT TYPE
NPN-type: Current sinking open collector
PNP-type: Current sourcing open collector
NPN-type: Totem pole (current sinking)
PNP-type: Totem pole (current sourcing)
Note: DIP switches 3 thru 8 are not used; factory default for both DIP switches is OFF.
1.4 RF Link switch
The RF Link switch allows users to select between the 14 different Limitless™ outputs to view the RF link strength
of a specific Limitless™ input. The five (5) blue LEDs will then indicate the RF link strength of the Limitless™ input
and corresponding output that is chosen (reference section 1.5.6). The following chart identifies the switch position
that is related to each Limitless™ input/output.
Switch position NPN/PNP Input/Output # - RF Link strength displayed
0 None-Normal operation
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8
9 9
A 10
B 11
C 12
D 13
E 14
F None-LED test mode
Note: Factory default switch position is zero
1.5 Functional Indicator
The Limitless™ WDRR Series has several LEDs to indicate various states, functions, actions, etc. The LEDs
functions will be described in this section and their indication will depend on the position of the RF Link switch

1.5.1 Power LED

Refer to Figure 1. One green LED turns on to indicate power is applied to the WDRR receiver. This occurs when
the electrical power is supplied to the "+"
6 Honeywell Sensing and Control


, NPN/PNP-type "low battery" output
identified as "1" and "2" on the DIP switch housing can be set to interface with a

DIP SW 1 LOGIC
OFF
ON
OFF
ON


and "-"

, and NPN/PNP-type "Lost RF Link" output

power supply terminals.
50063986
Issue 2,
DIP SW 2 LOGIC
OFF
OFF
ON
ON

.