Step Action - Honeywell Limitless WDRR Series Quick Start Manual

Limitless™ WDRR Series
Step Action
1 Completely read this procedure before starting in order to understand the timing of events that need to be
performed.
2 Limitless™ switch: Remove (if required) the two screws
Limitless™ switch and locate the function button
3 WDRR: Press the Function button
eight seconds at which time the green and yellow LEDs
release the function button immediately as it has entered the pairing mode.
4 Limitless™ switch: Within a 30 second interval of Step 3, depress the Limitless™ switch function button
(See Figure 5) and hold depressed for more than one second and less than 12 seconds at which time the
orange  LED turns on (see Figure 5). While in pairing mode, the orange led will flash on for 100 ms every
second. The orange
does not succeed, the orange
5 WDRR Receiver: Successful pairing will be indicated by the green and amber LEDs
ceasing to flash and remaining on for a few seconds before turning off. The specific Tricolor Output LED will
also turn on.
6 To confirm proper pairing between the Limitless™ switch and WDRR, actuate the Limitless™ switch, and
the Tricolor Output LED
7 Record the Limitless™ switch Sequence # on identification labels
housing in desired locations (See Figure 6).
8 Repeat Steps 2-7 to add additional Limitless™ switch. Up to 14 Limitless™ switches can be paired to a
single WDRR.

on WDRR (See Figure 4) for more than four seconds and less than
LED flashes three times 100 ms on, 100 ms off when pairing succeeds. If pairing

 LED will turn off and user will need to repeat steps starting with Step 3.

(see Figure 1) should turn on to indicate the proper output status.
on the housing cover (See Figure 3) of the

 (see Figure 4) to be used in Step 4.
(see Figure 4) will be flashing which indicates to

and apply to the Limitless™ switch

50063986
Issue 2,
(see Figure 4)

Honeywell Sensing and Control

9