Function Button - Honeywell Limitless WDRR Series Quick Start Manual

Limitless™ WDRR Series

1.5.5 Function Button

The Function button allows the Limitless™ WDRR Receiver to enter many different configuration modes such as
Set-up, Pairing, Purge, etc. while the configuration LEDs will indicate the different modes as well as different states.
This Quick Start Guide (QSG) will only show the use of the function button and configuration LEDs when in the
Pairing Mode (see Section 1.7) and Start-up or Restart Sequence (see Section 1.6)
1.5.6 RF Link Strength LEDs
The five (5) blue LEDs indicate the RF Link Strength
Limitless™ input change of state/actuation) with the WDRR Receiver. One (1) blue LED on indicates a weak RF
link and the increased number of blue LEDs on indicates a stronger RF link.
1.6 Start-up or Re-start Sequence

Apply power to the "+"

Configuration LEDs will indicate that the Limitless™ WDRR is ready for use:
Zero switches paired to the WDRR: The Configuration LEDs
performs a channel scan. Afterwards, all Configuration LEDs
illuminate. This indicates power is being supplied to the Limitless™ WDRR, and the unit is ready to use.
One or more switches paired (per Section 1.7) to the WDRR: The Configuration LEDs
few seconds while the WDRR performs a channel scan. The WDRR Receiver will then enter a System Check Mode
for up to two minutes. The red, yellow, and green Configuration LEDs
check is successfully completed. At which time, all Configuration LEDs
will illuminate indicating power is being supplied to the WDRR. The Limitless™ WDRR is ready to use, and will also
display the status of tri-color output LEDs
assuming the RF Link switch
1.7 Pairing Mode (Factory Default: No Limitless™ Inputs Paired)
Pairing is required to initiate and establish an RF communication link between a single WDRR and a single
Limitless™ input. The Limitless™ input example used in this Quick Start Guide (QSG) will be the Limitless™
WGLA switch.
The Limitless™ switch is shipped from the factory with two identification labels
recommended to be completed and applied to the Limitless™ switch housing during the pairing mode. As there are
up to 14 Limitless™ switches that can be paired to a single WDRR, these labels will be used to identify the
Limitless™ switch in the sequence of #1 to #14. The initial Limitless™ switch paired to the WDRR receiver will be
Sequence #1 (corresponding to output #1); the second Limitless™ switch paired will be Sequence #2
(corresponding to output #2) and so on.
The battery will need to be activated in the Limitless™ switch and proper power applied to the WDRR Series
Receiver before proceeding with this pairing procedure. Once the pairing is completed, the Limitless™ switch
selected will only communicate with the WDRR Receiver it was paired to and no other device.
8 Honeywell Sensing and Control
and Configuration LEDs



and "-" power supply terminals and the following describe how the WDRR

, low battery output LED

is in position "0".
Operation


of the Limitless™ input when communicating (i.e.

will illuminate for a few seconds while the WDRR

will turn off and only the green power LED

illuminate sequentially until the system

will turn off, and the green power LED

, and lost RF signal output LED
50063986
Issue 2,

will illuminate for a
(see Figure 5) that are


will

