Siemens SINUMERIK 840DE sl Commissioning Manual page 144

Customizing the "Machine" operating area
8.10 Manual machine
Bit 5
SD43200 $SA_SPIND_S
SD43202 $SA_SPIND_CONSTCUT_S
SD43206 $SA_SPIND_SPEED_TYPE
Additional parameter assignments
We recommend the following additional parameter assignments:
Handwheel
MD11346 $MN_HANDWH_TRUE_DISTANCE = 3
MD11602 $MN_ASUP_START_MASK bit 0, 3 =1
MD20150 $MC_G_CODE_RESET_VALUE [7] = 2
MD20624 $MC_HANDWH_CHAN_STOP_COND = 0xFFFF
MD32084 HANDWH_STOP_COND = 0x7FF
MD52212 FUNCTION_MASK_TECH Bit 9 = 1
Note
If, in machine data MD52212 FUNCTION_MASK_TECH bit 9 is set, the "WO selection" softkey
is displayed in the "Work Offset – G54 ... G599" window.
Working area limits
MD28600 $MC_MM_NUM_WORKAREA_CS_GROUPS > 0
MD20150 $MC_GCODE_RESET_VALUES[59] = 2
Note
If $MC_GCODE_RESET_VALUES[59] = 2 is set in the MD20150 machine data, the "Limit
stops" softkey is displayed in the "Manual Machine" window. This requires that
$MC_MM_NUM_WORKAREA_CS_GROUPS also has the value 1 for MD28600.
130
Enable spindle control, tool spindle
= 0 via the NC/PLC interface
= 1 via the user interface
Speed for spindle start using NC/PLC
interface signal; value outputs using
the operating software
Cutting speed for spindle start using
NC/PLC interface signal; value outputs
using the operating software
Spindle speed pipe for spindle start us‐
ing NC/PLC interface signal; value out‐
puts using the operating software
Handwheel path or velocity specifica‐
tion
Ignore stop conditions for ASUB
Delete position of the G groups; run-up
G54 active
Definition of the behavior of traveling
with handwheel, channel-specific
Behavior, handwheel travel
Function screen form across technolo‐
gies; work offset via softkey
Number of coordinate system-specific
working area limits
Delete position of the G groups; acti‐
vate working area limits of the group
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
SINUMERIK Operate (IM9)