Picklist Mode; Power Mode - Honeywell Marathon Programming Manual

Picklist Mode

Picklist mode enables the decoder to decode only bar codes that are aligned under the laser crosshair. Select one of the
following picklist modes for the decoder:
• Disabled Always - Picklist mode is always disabled.
• Enabled Always - Picklist mode is always enabled.
* Disabled Always
Enabled Always

Power Mode

Note: The Marathon is designed to be operated in Low Power Mode. Honeywell recommends leaving this value unchanged.
A parameter setting of Continuous On means the laser will not power down until the mobile device is powered off.
A parameter setting of Low Power means the laser will enter low power consumption mode after each decode attempt.
Pressing the Scan button will begin another decode sequence.
See Also: Time Delay to Low Power
Select a Power Mode by scanning either of the bar codes shown below.
Continuous On
* Low Power
2 - 12
Mode.