Convert Code 39 To Code 32; Set Length(S) For Code 39; One Discrete Length (Parameter L1) - Honeywell Marathon Programming Manual

Convert Code 39 to Code 32

Note: Code 39 must be enabled in order for this parameter to function.
Set this parameter by scanning either of the bar codes shown below.
Enable Convert Code 39 to Code 32
* Disable Convert Code 39 to Code 32

Set Length(s) for Code 39

Lengths for Code 39 may be set for:
• any length,
• one or two discrete lengths,
• or lengths within a specific range.
The length of a code refers to the number of characters, including check digits, the code contains. If Code 39 Full ASCII is
enabled, Length Within a Range or Any Length are the preferred options.
See the table titled ASCII Character

One Discrete Length (Parameter L1)

This option decodes only those codes containing a selected length. For example, when you want to scan only Code 39
symbols containing 14 characters, scan the following bar code and then "1" and "4" bar codes using the
Number Symbols. Single digits must be preceded by a zero. Default = 2.
To begin setting one discrete length, scan this One Discrete Length bar code:
Next, scan two numeric bar codes that correspond to the desired value. Single digit numbers must have a leading zero.
To correct an error or to change a selection, scan
2 - 44
Equivalents.
Cancel on the Imager Keypad Number Symbols page. Default = 55.
Imager Keypad