System - GE -DSH-73 User Manual

Chapter 5: Web-Based Management
NOTE:
1. We recommend using Internet Explorer 6.0 or above to access GE-DSH-82 series
Managed Industrial Switch.
2. The changed IP address take effect immediately after clicking on the Save button.
You need to use the new IP address to access the Web interface.
3. For security reasons, please change and memorize the new password after this
first setup.
4. Only enter commands in lowercase letters when using the web interface.

System

Use the System menu items to display and configure basic administrative details of
the Managed Industrial Switch. Under System the following topics are provided to
configure and view the system information: This section has the following items:
System Information
IP Configuration
DHCP Server
TFTP
Fault Relay Alarm
SNTP Configuration
IP Security
User Authentication
Factory Default
System Reboot
46
Provides basic system description, including contact information
Sets the IP address for management access
Configure the Switch as a DHCP server for assigning dynamic IP
addresses to devices on a network.
Upgrade the firmware via TFTP server
Save/view the switch configuration to remote host
Upload the switch configuration from remote host
Provides relay output for port breakdown, power fail
Simple Network Time Protocol. Configures SNTP client settings, including
broadcast mode or a specified list of servers
Supports 10 IP addresses that have permission to access the switch
management and to prevent unauthorized intruder.
Allows configuring the system user name and password required to
access the web pages or log in from CLI.
Reset the configuration of the Managed Industrial Switch
Restarts the switch
GE-DSH-73/DSH-82 and DSH-82-PoE User Manual