Trunk Commands Set - GE -DSH-73 User Manual

Chapter 6: Command Sets

Trunk Commands Set

Commands
aggregator priority
[1~65535]
aggregator activityport
[Group ID]
[Port Numbers]
aggregator group
[GroupID] [Port-list]
lacp
workp
[Workport]
aggregator group
[GroupID] [Port-list]
nolacp
show aggregator
no aggregator lacp
[GroupID]
no aggregator group
[GroupID]
142
Level Description
G Set port group system
priority
G Set activity port
G Assign a trunk group with
LACP active.
[GroupID] :1~3
[Port-list]:Member port list,
This parameter could be a
port range(ex.1-4) or a port
list separate by a
comma(ex.2, 3, 6)
[Workport]: The amount of
work ports, this value could
not be less than zero or be
large than the amount of
member ports.
G Assign a static trunk group.
[GroupID] :1~3
[Port-list]:Member port list,
This parameter could be a
port range(ex.1-4) or a port
list separate by a
comma(ex.2, 3, 6)
P Show the information of
trunk group
G Disable the LACP function of
trunk group
G Remove a trunk group
Example
switch(config)#aggregator
priority 22
switch(config)#aggregator
activityport 2
switch(config)#aggregator
group 1 1-4 lacp workp 2
or
switch(config)#aggregator
group 2 1,4,3 lacp workp 3
switch(config)#aggregator
group 1 2-4 nolacp
or
switch(config)#aggregator
group 1 3,1,2 nolacp
switch#show aggregator 1
or
switch#show aggregator 2
or
switch#show aggregator 3
switch(config)#no aggreator
lacp 1
switch(config)#no aggreator
group 2
GE-DSH-73/DSH-82 and DSH-82-PoE User Manual