Table of Contents
Advertisement
-
-
d.
SECTION III.
TYPE 123 CARD READER
Press the START switch.
If it is desired to stop the card
reader while reading operations are in progress, the STOP
switch TI1ay be pressed.
51-COLUMN
POSITION
Restart Procedures
1.
To restart following a STOP switch depression (a norTI1al stop with no error
conditions indicated):
a.
Press the START switch.
2.
To restart following a stop condition for a CARDS indication:
a.
Refill the eTI1pty input hopper or eTI1pty the full output stacker
as required, and/ or insure that cards are pressed against the
stacker rolls.
NOTE:
When the reader is running, care should be taken
in reTI10ving cards froTI1 the output stacker to avoid
a possible CARDS indication and a subsequent halt.
b.
Press the START switch.
3.
To restart following a stop condition for an INPUT indication:
a.
ReTI10ve the reTI1aining cards froTI1 the input hopper or slide
the deck up the hopper.
The cards causing the feed failure
are nearest the throat (as the deck is reTI1oved).
These
cards TI1ay or TI1ay not be daTI1aged or bent out of shape.
b.
If the cards are daTI1aged or bent out of shape, place theTI1
on a flat surface and, with any suitable instruTI1ent, STI100th
out the rough or bent edges.
If the cards cannot be restored
to a usable condition, they should be replaced with new cards.
3-7
Advertisement
Table of Contents
