Connect To An Ethernet Network - Honeywell ScanPal EDA71 User Manual

3. Tap and hold the name of a connected network, and then tap Modify network.
4. Tap Advanced options.
5. Under Proxy, tap None to open menu, and then select Manual.
6. Enter the proxy settings for the network.
7. Tap Save.
Disable Wi-Fi Notifications and Set WLAN Radio Sleep Parameter
By default, when Wi-Fi is enabled, you receive notifications in the Status bar when
the computer discovers a wireless network. You can disable these notifications.
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Settings
3. Navigate to the bottom of the discovered network list.
4. Select Wi-Fi preferences.
5. Tap Open network notification to toggle the setting On or Off.

Connect to an Ethernet Network

To connect the computer to an Ethernet network, you need a EDA71 Ethernet
Home Base or a EDA71 Net Base.
1. Make sure the base is connected to your Ethernet network.
2. Place the computer in the base.
3. Swipe up from the bottom of the Home screen to access all apps.
4. Tap Settings
5. Tap Ethernet.
6. (Optional) To assign a static IP address.
7. Tap Save.
56
> Networks & Internet > Wi-Fi. Verify the WLAN radio is
turned On.
> Network & Internet > Ethernet. The Ethernet setting is
turned On by default.
The Ethernet connection screen shows the current Ethernet connection. By
default, the computer assumes a DHCP connection, and that your network has
assigned an IP address automatically. If DHCP is working, the Ethernet base
should indicate that communication with the network is occurring.
a. Tap DHCP and then select Static from the list.
b. Enter the required network information, and then tap Apply.
EDA71 User Guide