Advertisement
19. Re-install top plate as shown in Figure 15.
Figure 15. Top plate installation.
20. Position deadman arm and deadman, as
shown in Figure 16, and use a 6mm hex
wrench to secure cap screws.
Deadman
Deadman Arm
Figure 16. Deadman and arm installation.
21. Turn taper angle control knob (see Figure
17) until dovetail slide is parallel with bed.
Taper Angle
Control Knob
Figure 17. Taper angle control knob.
T10096 Taper Attachment
Top Plate
Cap Screw
22. Use a 6mm hex wrench to tighten dovetail
lock cap screws (see Figures 17 and 18).
One screw is located at each end of taper
attachment dovetail.
23. Move carriage so taper attachment stops
completely at rearmost position (see Figure
18).
24. Set up a dial indicator (see Figure 18), so
dial indicator point is against top of dovetailed
way.
Figure 18. Parallelism verification.
25. Move carriage to other end of way. Read dial
indicator and note amount of total misalign-
ment in parallelism between path of carriage
and path of taper attachment.
Readings on dial indicator showing a tilt of
0.050" or less between two extreme posi-
tions of thetaper attachment are acceptable
and have no significant impact on taper
operations.
Cap Screw
Taper
Scale
-5-
Advertisement
