Firmware Upgrade - GE QuickPanel+ IC755CxS06RDx User Manual

3.9.1

Firmware Upgrade

Note This utility operates similar to the QuickPanel
The operator can continue to use the QuickPanel
The Firmware Upgrade utility setting enables operators to upgrade the firmware. Firmware updates are not supported
over
Ethernet or Serial interfaces. Insert the media (SD Card) containing the required files for firmware upgrade and perform
the following procedure.
Note Make sure the copy of required binaries to the SD card is not within a folder.
Note The firmware package contains encrypted .nbo files. Use the PreUpdate.exe tool to decrypt the .nbo files before
using them for upgrade.
After a firmware upgrade, which refreshes the device fresh, the user must download the project again and install
their own tools (including third party tools) on the device.
Note It is recommended that the user back up any important data prior to firmware upgrade so that they can replace
the data after firmware upgrade if necessary.
Attention
30 GFK-2847W
For public disclosure
Update Tool, which comes with the OS image upgrade binaries.
+
Update Tool to use the DIP Switch feature.
+
If the current firmware build version on the QuickPanel
to the section Firmware Upgrade for Specific Build
• Build 3 or below for IC755CxS06RDx
(6" Display)
• Build 23 or below for IC755CxW07CDx
(7" Display)
• Build 14 or below for IC755CxS10CDx
(10" Display), IC755CxS12CDx
(12" Display), and IC755CxS15CDx
(15" Display)
is any of the following, refer
+
Version:
QuickPanel⁺ Operator Interface User
Manual