Installing The Mvme2300 Module - Motorola MVME2300 Series Installation And Use Manual

1. Attach an ESD strap to your wrist. Attach the other end of the ESD
2. Perform an operating system shutdown. Turn the AC or DC power
3. If the primary PMC carrier module/MVME2300 assembly is
4. Remove the four short Phillips screws from the standoffs in each
5. Attach the four standoffs to the PMCspan-002.
6. Place the PMCspan-010 on top of the PMCspan-002. Align the
7. Gently press the two PMCspan modules together, making sure that
8. Insert the four short Phillips screws through the holes at the corners
Note

Installing the MVME2300 Module

Before installing the module in your VME chassis, make sure that jumpers
J15 and J16 are configured. This procedure assumes that you have already
installed the PMCspan(s) if desired, and any PMCs that you have selected.
1-19
strap to the chassis as a ground. The ESD strap must be secured to
your wrist and to ground while you are performing the installation
procedure.
off and remove the AC cord or DC power lines from the system.
Remove chassis or system cover(s) as necessary for access to the
VMEmodule card cage.
already installed in the chassis, carefully remove the two-board
assembly from the chassis. Position connectors P1 and P2 facing
you.
corner of the primary PCI expansion module, PMCspan-002.
mounting holes in each corner to the standoffs, and align PMCspan-
010 connector P3 with PMCspan-002 connector J3.
connector P3 is fully seated in J3.
of PMCspan-010 and into the standoffs on the primary
PMCspan-002. Tighten the screws.
The screws have two different head diameters. Use the screws
with the smaller heads on the standoffs next to VMEbus
connectors P1 and P2.
Installing the MVME2300 Hardware
1