Figure 1-3. Typical Single-Width Pmc Module Placement On Mvme2300 - Motorola MVME2300 Series Installation And Use Manual

Preparation and Installation
1

Figure 1-3. Typical Single-width PMC Module Placement on MVME2300

1-14
1. Attach an ESD strap to your wrist. Attach the other end of the ESD
strap to the chassis as a ground. The ESD strap must be secured to
your wrist and to ground throughout the procedure.
2. Perform an operating system shutdown. Turn the AC or DC power
off and remove the AC cord or DC power lines from the system.
Remove chassis or system cover(s) as necessary for access to the
VMEmodules.
3. If the MVME2300 has already been installed in the chassis,
carefully remove it. Position the module, with connectors P1 and P2
facing you.
4. Remove the PCI filler plate from the selected PMC slot in the front
panel of the module. If installing a double-width PMC, remove the
filler plates from both PMC slots.
Computer Group Literature Center Web Site
2064 9708