Installing The Primary Pmcspan - Motorola MVME2300 Series Installation And Use Manual

5. Slide the edge connector(s) of the PMC module into the front panel
6. Insert the two short Phillips screws through the holes at the forward
7. If installing two single-width PMCs, repeat the above procedure for

Installing the Primary PMCspan

To install a PMCspan-002 PCI expansion module on your module, refer to
Figure 1-4
you have read the user's manual that was furnished with the PMCspan, and
that you have installed the selected PMCs on the PMCspan according to
the instructions given in the PMCspan and PMC manuals.
Inserting or removing modules with power applied may result in damage
to module components.
Avoid touching areas of integrated circuitry; static discharge can damage
these circuits.
!
Caution
Dangerous voltages, capable of causing death, are present in
!
this equipment. Use extreme caution when handling, testing,
and adjusting.
Warning
1. Attach an ESD strap to your wrist. Attach the other end of the ESD
1-15
opening(s) from behind and place the PMC module on top of the
module. The four connectors on the underside of the PMC module
should then connect smoothly with the corresponding connectors
for a single-width PMC (J11/J12/J13/J14 or J21/J22/J23/J24, all
eight for a double-width PMC) on the module.
corners of the PMC module, into the standoffs on the module.
Tighten the screws.
the second PMC.
and perform the following steps. This procedure assumes that
strap to the chassis as a ground. The ESD strap must be secured to
your wrist and to ground while you are performing the installation
procedure.
Installing the MVME2300 Hardware
1