Removing A Power Supply Module - Cisco Catalyst 9600 Series Hardware Installation Manual

Installing a Power Supply Unit
Warning
This product requires short-circuit (overcurrent) protection, to be provided as part of the building installation.
Install only in accordance with national and local wiring regulations.
Statement 1045
Warning No user-serviceable parts inside. Do not open.
Statement 1073
Warning Hazardous voltage or energy may be present on DC power terminals. Always replace cover when terminals
are not in service. Be sure uninsulated conductors are not accessible when cover is in place.
Statement 1075

Removing a Power Supply Module

Before you begin
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
Warning No user-serviceable parts inside. Do not open. Statement 1073
Procedure
Step 1 Turn the power switch of the designated power supply module to OFF (0) position
Step 2
Loosen and remove the retainer strip that is around the power cord.
Step 3 Remove the power cord from the power receptacle on the power supply.
Step 4
Press the release latch at the right side of the power supply module inwards.
Cisco Catalyst 9600 Series Switches Hardware Installation Guide
Removing a Power Supply Module
77