Installing The Fan Tray From The Rear Of The Chassis - Cisco Catalyst 9600 Series Hardware Installation Manual

Installing the Fan Tray from the Rear of the Chassis

What to do next
Verify that you have installed the fan tray correctly. See
Installing the Fan Tray from the Rear of the Chassis
Before you begin
• Read
• Enable the service mode on the chassis, if you are performing this task in a system that is powered on.
• Ensure that you have the following tools and accessories available:
Procedure
Step 1
On the replacement fan tray assembly, ensure that the two screws securing the fantray to the connector (on
the side with the fan STATUS LEDs) are tight. Be careful not to overtighten the screws.
Step 2
Hold the fan tray assembly such that the side with the STATUS LED is inserted first.
Figure 38: Inserting the Fan Tray from the Rear of the Chassis
Cisco Catalyst 9600 Series Switches Hardware Installation Guide
72
Guidelines for Removing and Installing a Fan Tray, on page
• Phillips-head screwdriver
• Anti-static mat
Verifying Fan Tray Installation, on page
63.
Installing the Fan Tray
73.