Grizzly G0733 Owner's Manual page 19

4.
If bolting the lathe to the floor, skip to
Step 7. Otherwise, move the tailstock, tool
rest assembly, and headstock to one end of
the lathe bed (refer to OPERATIONS section,
beginning on Page 19, for instructions for
moving these components).
5. Use assistants to lift one end of the lathe
onto support blocks and stabilize the lathe
in preparation for installing the machine feet
(see Figure 12).
Figure 12. Legs supported for feet installation.
6. Remove the top hex nut from the feet, then
insert the feet into the mounting holes of the
leg (see Figure 13). Do not tighten the hex
nuts yet. Remove the supporting block and
repeat Steps 5–6 on the other leg.
Figure 13. Machine feet installed.
Model G0733 (Mfd. Since 5/19)
Support Block
7.
Place the level on the lathe bed and make
necessary adjustments so that the bed is
level from side-to-side and front-to-back.
—If you are using the machine feet, adjust
the top and bottom hex nuts on each leg to
level the bed; then tighten the hex nuts to
secure these adjustments.
—If you are bolting your lathe to the floor, use
shims under the legs to level the bed; then
tighten the mounting fasteners.
8.
Insert the tool rest into the tool rest base and
tighten the tool rest lock handle, as shown in
Figure 14.
Tool Rest Base
Figure 14. Tool rest installed on the tool rest
base.
9.
Attach the storage basket to the leg using
(2) M8-1.25 x 35 cap screws, (2) 8mm lock
washers, and (2) M8-1.25 hex nuts, as shown
in Figure 15.
Leg
Figure 15. Attaching basket to leg.
Tool Rest
Tool Rest
Lock Handle
Basket
-17-