Maintenance; Cleaning The Hepa Filter - Makita XCV10 Instruction Manual

State of abnormality
Cannot erase all tool registrations in
the cleaner.

MAINTENANCE

CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed before
attempting to perform inspection or maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.

Cleaning the HEPA filter

CAUTION:
Do not use the vacuum cleaner without a
filter or continue to use dirty or damaged filter. Vacuumed
dust or particles may be exhausted from the cleaner and
they may cause respiratory disease to the operator.
NOTICE:
To keep optimum suction power and
clean exhaust, clean the filter periodically. If
enough suction power is not obtained even after
the cleaning, replace the filter with new one.
NOTICE:
To prevent the filter from being dam-
aged, do not use following tools and similar items
for cleaning :
— Air duster
— High pressure washer
— Tools made of hard materials such as a
metallic brush
1.
Open the lid and take out the filter bag. Release the
hook on the filter and remove it from the vacuum cleaner body.
Probable cause (malfunction)
Pressing the wireless button on the tool. Press the wireless button on the cleaner for erasing
The stand-by switch on the cleaner is
not set to " I (ON)".
The wireless activation button is not
held down correctly.
20 ENGLISH
Remedy
all tool registrations.
Set the stand-by switch on the cleaner to " I (ON)".
Hold down the wireless activation button for more
than 6 seconds and then release it when the wire-
less activation lamp blinks in red. Hold down the
wireless activation button for more than 6 seconds
again until the wireless activation button rapidly
blinks in red and then release the button.
2. Beat the dust off from the filter. The filter can be
washed with water. Rinse away the dust and particles
on the filter every 1 or 2 month. After that, dry the filter
completely in a shaded and well-ventilated place to
prevent unpleasant odor or malfunctions.
3.
To install the filter, insert the side without the flap
into the holder then push the filter downward until the
flap is secured by the rib.
1
3
► 1. Holder 2. HEPA filter 3. Rib 4. Flap
2
4