Pcmcia Pending" Message Is Displayed On The Recorder; Pcmcia Triangle Does Not Appear On The Display When Archiving; N O Data Have Been Written On The Card - Honeywell DPR180 Manual

6.6 "PCMCIA PENDING" message is displayed on the recorder

CHECK
Check the PCMCIA STATUS in
PCMCIA / SERVICE :
PCMCIA MISSING
PCMCIA BAD
PCMCIA NOT INIT
PCMCIA PRESENT

6.7 PCMCIA triangle does not appear on the display when archiving

CHECK
Check INTERFACE parameter in
MISCELLANEOUS / Read/Write
Check START parameter in
PCMCIA / Read/Write
Is PCMCIA PENDING displayed
on the MMI ?
6.8 No data have been written on the card
CHECK
Check START parameter in
PCMCIA / Read/Write
Was PCMCIA PENDING displayed
on the MMI ?
Check ROLLOVER parameter in
PCMCIA / Read/Write
32
DIAGNOSTIC / ACTION
The archive is ON and no card has been inserted in the
driver. Insert a card to turn off the display.
The archive is ON and the inserted card is bad. Refer to §
6.5 to check card validity or insert a valid card.
The archive is ON and the inserted card is not initialized.
Refer to § 6.4.
The card has been initialized but part of the archiving
configuration stored on the card does not match with the
configuration of the recorder. Press RESET key and select
RESET PCMCIA menu to make both configurations match.
WARNING A RESET PCMCIA will erase all previous
data stored on the card.
DIAGNOSTIC / ACTION
Turn parameter to PCMCIA.
If the archive is triggered by an alarm or a digital status,
check alarm or digital status which should start the
archiving (Press the DISPLAY key and select ALARM
STATUS or LOGIC STATES).
Refer to § 6.6
DIAGNOSTIC / ACTION
The archiving start condition has not been met. No data
have been stored on the card.
Refer to § 6.6
If ROLLOVER is set on DISABLE, check in DIRECTORY
(PCMCIA / SERVICE) the amount of records that it is still
possible to store. If this amount is 0, no data will be
recorded on this file. Turn ROLLOVER to ENABLE or
either reset or initialize the card.
PCMCIA Option Manual