Table of Contents
Advertisement
35.
Replace the CPU board protection cover.
Replace the 3 fixing screws.
36.
Replace the slot covers.
37.
Replace the power supply. Replace the 2 rightest fixing screws.
38.
Slide the recorder chassis back into the outer case.
39.
Replace the 4 fixing screws (M4) with the Torx key T20. (See ref. B, Figure 2-4)
40.
Replace all terminal blocks and grommets.
41.
Replace the rear cover. Replace the 3 fixing screws. (See ref. A, Figure 2-2)
42.
Reconnect the main supply to the power supply terminal block.
43.
Replace the power supply terminal block cover. (See ref. E, Figure 2-15)
44.
Turn ON the switch. (See Figure 2-1).
45.
Replace the chart cassette.
46.
Switch ON the main supply.
47.
Upgrade your recorder firmware if the revision is lower than 001AK. (See CK 214).
Figure 2-14
PCMCIA Option Manual
11
Hide quick links:
Advertisement
Table of Contents
