Connectors And Cabling; Input Power - GE PACSystems ICRXIDIXNE19LCTA User Manual

5 Connectors and Cabling

Port Name
24 V dc
Ethernet 1
Ethernet 2
Serial RS-232
USB 1
USB 2
VGA Video
SD Card slot
Audio
1 Shielding is required to be in compliance with the standards identified in
2 Can be permanently connected while the system is running
3 Intended only for temporary connection

5.1 Input Power

To connect the dc power
supply, refer to the section
Initial Startup.
Connectors and Cabling
For public disclosure
This chapter describes the connector layout and cabling requirements on the RXi Display,
as well as power and communication connectors. All connectors except the SD card
interface are provided on the bottom panel of the RXi Display.
Summary of Cabled Ports
Usage
Permanent 2
Permanent 2
Permanent 2
Permanent 2
Maintenance 3
Maintenance 3
Maintenance 3
3
Maintenance
Maintenance 3
The RXi Display requires the following power input power connection:
• 24 V dc, 18 – 32 V range, 65 W power supply
Warning
Note The RXi Display is supplied with a Phoenix Contact part number 1827716
power terminal block plug. Phoenix Contact part number 1851245 (spring
loaded/quick release) power terminal block plug may also be used.
• Power cord with 24 –16 AWG wires; user calculates proper wire gauge according to
local regulations
Recommended Max Shielding
Cable Length Required
3 m (9.8 ft)
No
100 m (328 ft)
Yes
100 m (328 ft)
Yes
10 m (32.8 ft)
Yes
5 m (16.4 ft)
Yes
5 m (16.4 ft)
Yes
7.6 m (25 ft)
Yes
N/A N/A
2 m (6.5 ft)
No
Appendix A.
The power supply used should be a UL listed
power source providing voltage isolation with a
SELV output, or a Class 2 power source. A
readily accessible disconnect device shall be
incorporated in the building installation wiring.
1
1
1
1
1
1
GFK-2898B 33