Operation - Makita AG125 Instruction Manual

3
1
2
1. Nail shank
2. Nail tip
3. Nail head
1
3
1. Nail
2. Magnet
3. Nail guide
4. Contact arm
1. Air fitting
2. Air socket

OPERATION

2
1. Driving surface
2. Trigger
Loading nailer
005371
CAUTION:
• Be careful not to touch the trigger when loading the nail.
• When loading nail into the nailer, grip the nail by the shank, not the tip.
Hold the nail shank lightly and insert the nail head into the nail guide until the
nail is held firmly by the magnet.
005372
2
4
Connecting air hose
005374
Slip the air socket of the air hose onto the air fitting on the nailer. Be sure that
1
the air socket locks firmly into position when installed onto the air fitting. A
hose coupling must be installed on or near the tool in such a way that the pres-
sure reservoir will discharge at the time the air supply coupling is discon-
nected.
2
005375
1 CAUTION:
• Make sure the safety system is in working order before operation.
To start driving, place the tip of the nail against the driving surface and pull the
trigger. At the start of driving, apply gentle downward pressure on the nailer in
the arrow direction to hold the nail firmly. When the impact of the contact arm
stops, the driving operation is over. If the nail is not driven deep enough, place
the ejection port of the nailer over the nail head. Press the nailer against the
driving surface firmly and pull the trigger to do additional driving of the nail.
7