Advertisement
Installation - Latch Assembly
Installation Procedure - Latch Assembly
Installing Latch Assembly Kit
1. Put round washer (30756218-002)
on barrel (30756208-001).
NOTE: If steel door use
30756218-001.
2. Insert barrel through hole from
front of door.
6. Push latch
(30756100-001)
into barrel with pawl
pointing down.
5. Lubricate O-ring (30756216-001)
with silicon grease and slip it on outside
of barrel.
Installing Latch on Chart Plate
1. Remove rubber O-ring from back of
captive screw in chart plate.
2. Position retaining latch (30756102-001)
in rectangular cutout of chart plate. Insert
10-32 screw (30674113-012) through
retaining latch and slip rubber O-ring over
screw from back of chart plate.
3. Close chart plate and secure with captive screw.
NOTE: Always secure chart plate to case
before engaging latch.
4. Close and latch door.
2 of 4
NOTE: If you are installing the latch
3. For DR 4200, push housing retainer
door
Kit Instruction 44-45-33-33B
on a steel door, skip Step 3.
(30756101-001) with tab facing
down over barrel.
For DR 4500 & DR 4500A, push
housing retainer (30756204-001)
with rectangular cut edge facing down
over barrel.
4. Install retaining nut
(30756209-001) to
secure barrel.
7. Put "D" shaped hole of cam
(30756207-001) on latch with
large edge of cam facing down.
Secure cam to end of lock cylinder
with washer (30004950-000)
and #10 screw (3000005-004).
8. For proper installation, latch must
turn counterclockwise to open as
viewed from front of door.
06/26/13
Advertisement
