Buffalo TeraStation User Manual page 7

2
Hold down the power button on the TeraStation for three seconds to turn it on.
3
Wait until the green power LED changes from ashing to lit. In the TS-RXL TeraStations, the LED is
not illuminated. Continue to Step 4.
4
Insert the TeraNavigator software CD into your computer. The TeraNavigator wizard will launch.
Click Begin Installation.
Notes:
• If you are using Windows 8, Windows 7 or Vista, the autoplay screen may appear. Click Run TSNavi.exe.
• If "Do you want to allow the following program to make changes to this computer ?" is displayed in Windows 8
or Windows 7, click Yes.
• If "A program needs your permission to continue" is displayed in Windows Vista, click Continue.
• For Mac OS, open the CD and double-click the TeraNavigator icon.
• Disable your antivirus software or rewall before continuing. The TeraNavigator software may not install
properly if antivirus or rewall is enabled. Re-enable antivirus and rewall after setup.
When "Finish" is displayed, initiate NAS Navigator2 by clicking Launch NAS Navigator2.
5
Note: Alternately, you can click Next to display more information about the power mode switch, which can turn
the TeraStation on and o automatically.
6
TeraStation User Manual
Note:
If the wizard doesn't open automatically, navigate to the TeraNavigator CD
and double-click the
Step through the wizard to connect cables and install software.
Right-click your TeraStation's icon, and choose Properties - IP Address.
Note:
For Mac OS, hold the Control key, click the TeraStation icon, then click Con gure -
IP Address.
icon (TSNavi.exe).
6