Buffalo TeraStation User Manual page 43

Configure replication as described below.
1
2
Click Add.
3
4
Read the alert message carefully and click OK.
Replication is configured.
Replication to a TeraStation on a different network
If your target TeraStation is on a different network or subnet, you may still configure replication as described above, but
you must first add the target TeraStation to your list of off-subnet TeraStations as described below.
1
2
3
Click Close.
You can now configure Replication as described in the previous section.
TeraStation User Manual
In the source TeraStation's settings, click System - Backup - Replication.
1 Select replication source folder for Backup Source.
2 Select replication target folder for Backup Targets.
3 Click Save.
In the source TeraStation's settings, navigate to System - Backup. Click View
NAS Devices.
Under "Off Subnet TeraStations", enter the target TeraStation's IP address
in the "New IP Address" field. Click Add.
Note: If the Target TeraStation is behind a router, enter the router's WAN
side IP address. You will need to map ports 873, 22938, and 22939 to the
target TeraStation in the router for this to work correctly.
42