Ground Connections - Honeywell Sensepoint XRL Instruction Manual

Installation

2.9 Ground Connections

24
CAUTION
Do not over-tighten the terminal screw.
5. Feed the cable through the cable
gland.
6. Pull the terminal blocks to remove
them from the connector module.
7. Connect cables to the terminal
blocks, referring to the relevant
wiring diagram. Strip and insert the
end of each wire into the
corresponding terminal hole. Using a
flat-blade terminal screwdriver,
tighten the terminal screw until the
wire is secured. Use a ferrule on the
wire where necessary.
8. Replace the terminal blocks in their
correct positions.