Installation Layout; Power Cable Specification - Honeywell Sensepoint XRL Instruction Manual

2.2 Installation Layout

2.3 Power Cable Specification
1) A gas detection system using Modbus RTU. Detectors are wired on a single
cable run.
2) A gas detector system using analog current loop principle. Each detector
is individually wired to the controller on its own cable.
Final positioning of gas detectors should be indicated by the
characteristics of the gas being detected and other environmental
factors. Seek advice from experts where necessary.
CAUTION
Sensepoint XRL shall be installed on a flat surface or other suitable
structure. For installation on a pole or pipe, use the official pole
mount kit accessory. Sensepoint XRL sensor's sinter must be
pointing downward.
Sensepoint XRL requires a power supply from the controller of specified
supply voltage range in Section 1.6. Ensure that the minimum supply
Installation
15