Redundancy Synchronize - Dell C9000 Series Reference Manual

redundancy synchronize

Manually synchronize data between the RPMs and PEs at any time.
C9000 Series
Syntax
redundancy synchronize [full]
Parameters
full
Default Not configured.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.5.1.0
7.6.1.0
Data between the two RPMs or PEs is synchronized immediately after bootup. Once
the two RPMs or PEs complete an initial full synchronization (block sync), the Dell
Networking OS updates changed data (incremental sync).The data that is synchronized
consists of configuration data, operational data, state and status, and statistics
depending on the Dell Networking OS version.
Enter the keyword full to synchronize all data.
Description
Introduced on the C9010.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series.
Introduced on the E-Series.
High Availability (HA) 914